Towertalk
[Top] [All Lists]

Re: [TowerTalk] Which thruse bearing?

To: "'Bill Turner'" <dezrat@copper.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Which thruse bearing?
From: "Gary Schafer" <garyschafer@comcast.net>
Reply-to: garyschafer@comcast.net
Date: Wed, 13 Dec 2006 15:17:38 -0500
List-post: <mailto:towertalk@contesting.com>
A heavy wire or strap from mast to tower is best. You want a low resistance
ground. A wiper, spark gap etc. all have enough resistance to let current
thru the rotor.

73
Gary  K4FMX

> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Bill Turner
> Sent: Wednesday, December 13, 2006 12:37 PM
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Which thruse bearing?
> 
> Thanks for all the replies, guys. I think I'll abandon the thrust
> bearing as a grounding device and try something else. Perhaps a one
> inch wide copper or brass bar used as a wiper on the mast would do.
> I'll keep thinking about it.
> 
> 73, Bill W6WRT
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>