| To: | <towertalk@contesting.com> |
|---|---|
| Subject: | Re: [TowerTalk] Nicopress swags |
| From: | "Doug Rehman" <rehman@electronicdiscovery.com> |
| Date: | Fri, 8 Dec 2006 08:52:49 -0500 |
| List-post: | <mailto:towertalk@contesting.com> |
I haven't done 1/4", but I have done 3/16" with a hand crimper (large bolt cutter looking contraption). It isn't too bad a job. Avoid the hardware store crimpers- they're only designed for crimping aluminum. (Aluminum crimps aren't rated for vertical lifting.) Doug K4DDR _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TowerTalk] Ham IV vs Yaesu, JMLTINC |
|---|---|
| Next by Date: | [TowerTalk] 160m inverted l, ny6dx |
| Previous by Thread: | Re: [TowerTalk] Nicopress swags, Doug Rehman |
| Next by Thread: | Re: [TowerTalk] Nicopress swags, Eric Scace K3NA |
| Indexes: | [Date] [Thread] [Top] [All Lists] |