I have one and if I remember right but forgot to taken pictures
it is a single worm drive .no break.
I had a lot of troubles in the past ...the screw that hold the topplate
to the shaft broke off ,totally rusted after 2 years.I did some
modifications
to it beacuse the upper bearing holding the shaft got water inside
lucky there are 2 big holes at the underside of the rotor
Now it is ok turning my kt34xa ,but loose some times his direction
on the controller.Lucky there is a calibration routine.
Most people told my cable run is to long and I have to use coax ???
I got some emails but got a slow respons from M2 probely to busy
I ordered some 6 weeks ago the magnetspinner and the reedswitch
but no response from Jeremy anymore.I needed one for my homebrew
big rotator so now i build it by my self.
About the prosistel ,I have placed several of them .The first one I
got troubles with the pot and water.Whe send it back and i new one whas
delivered.
The new ones have no problem with it.This summer I placed a PST 71 turning
2 big optibeams at Doc ON4IZ.
There is another italian supplier for rotators http://www.antenna.it
Marc ON4MA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|