----- Original Message -----
From: <hdmc38@bellsouth.net>
To: <kb0fhp@comcast.net>; <kdm@ctcn.net>; <TowerTalk@contesting.com>
Sent: Sunday, November 12, 2006 5:28 AM
Subject: Re: [TowerTalk] Max Unguyed Rohn 25 height to support dipole end
> Hello Ken
> I think you would over load that 40' when you climb it.20 to 30 feet
> of 25G is pretty shakey when your on top with no guys.Just my .02 cents.
>
> Joe K4XZ
>>
That's why I recommend 20' of unsupported R25 followed by 20' of
reinforced aluminum mast. I use a couple of rotator clamp shells on
the rotator shelf of the R25 short top section along with an old TB-3
thrust bearing on the top plate to support the mast (grabs the mast
in two places about 1.5 feet apart). You can loosen the gib bolts on
the TB-3 and then loosen rotator clamp shells and drop the mast
down through the rotator cable pass thru in the rotator shelf if you
want to attach anything to the top of the mast (like for changing
pulley's for instance). That way you never have to climb more than
20 feet of unsupported R25.
73, Mike W4EF.........................
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|