Rob Atkinson, K5UJ wrote:
>You'll probably get 50 responses as everyone has their own way of doing
>this.
You're so right :-)
1. Someone wrote me with a clever and simple idea: file across the holes
using a 1/4-in round file, until the metal has been reduced to a thin
edge. This will be much easier to solder, and will also remove any
hard-to-solder plating.
2. An electric hot air gun (paint stripper) is probably cheaper than a
gas torch, and almost certainly cheaper than a monster iron.
3. Don't try to solder with the torch or hot-air gun. Use it only to
boost the temperature of the plug body, until your small iron can melt
the solder easily.
--
73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.co.uk/g3sek
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|