Check the connector on the rotator. I had a similar problem with a G-1000;
upon opening the connector shell, I found that water had gotten in and
dried. The contaminants in the water were conductive enough to mess up the
direction indicator. I cleaned out the connector using a toothbrush and
compressed air. After sealing it up with rubber splicing tape and
Scotchkote, I haven't had any more problems.
Doug
K4DDR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|