Towertalk
[Top] [All Lists]

Re: [TowerTalk] Using US Tower HDX-572MDPL Raising Fixture

To: DrD@2020.com
Subject: Re: [TowerTalk] Using US Tower HDX-572MDPL Raising Fixture
From: k2qmf@juno.com
Date: Sun, 29 Oct 2006 12:23:54 -0500
List-post: <mailto:towertalk@contesting.com>
Very Normal........... 

K2QMF

On Sat, 28 Oct 2006 20:26:30 -0400 "Dr M J DiGirolamo" <DrD@2020.com>
writes:
> Hi Gang,
> 
>         Some 10 days ago I used a crane to set my US Tower 
> HDX-572MDPL to its
> base.  
> 
>         Today I tilted it over using the "raising & lowering 
> fixture" so I could
> mount the rotator and set the mast in place.  However, I stumbled 
> upon the
> unexpected.  
> 
>         After removing all but the two hinging bolts, the tower did 
> not want to
> tilt on its own.  Tower was without a mast or antennas on it.  I 
> ended up using
> both a crow and lever bar to encourage it to tilt over.  I'd 
> estimate it was as
> much as 10 degrees off normal before there was enough lateral force 
> component
> for the tower to lower on its own as I let the cable out.
> 
>         Questions:  Is this normal?  Are there those with experience 
> who would
> share how they deal with this situation? 
> 
> 73,
> 
> Mike DiGirolamo, W4XN
> Charlottesville, VA
> 
>    
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> 
 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>