I know Rob means well and we hams should be capable of "doing it
ourselves" but in this day in age time is quite valuable. By the time
you purchase all of the tools Rob suggests (assuming you don't have them
already) and "pay" yourself an hourly wage I think many of us will find
that buying pre-made jumpers is cost effective. I know I do. And by
the way I buy from Joel at TheRFConnection. 73 bob de w9ge
Rob Atkinson, K5UJ wrote:
>hi Tommy,
>
>
> Get a pair of Kline coax cutters, xacto knife, silver rosin solder, small
>hand torch, vise to hold the cable with, pair of pliars, steel brush, and
>ohm meter to check for shorts/continuity and you'll be all set.
>
>rob / k5uj
>
>_________________________________________________________________
>All-in-one security and maintenance for your PC. Get a free 90-day trial!
>http://clk.atdmt.com/MSN/go/msnnkwlo0050000002msn/direct/01/?href=http://www.windowsonecare.com/?sc_cid=msn_hotmail
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|