I mentioned this before, my swr was fine just no bandwidth maybe 100khz. They
sent me a package
that cost $45 and consisted of two new 15 mtr element tips for the driven
element and two coupling
coils one each for 20 and 15mtrs. with instructions to re "dress the 20 to 10
mtr link". It still
didn't improve the bandwidth. Mine had the extra element to boom mount for
moving the 15 mtr driven
element for separate feed lines. About this time the SteppIR came out so I sold
it.
Larry K1ZW
Durham, NC
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Jim
McDonald
Sent: Friday, September 01, 2006 2:49 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] C31 - 1 feed line or 3
Using a single feed, my C-31XR resonated (measured in the shack, where my
transmitter is) well below
21.0 MHz (209??). N6BT suggested cutting an inch, I think he said, off the end
of each side of the
15M driven element.
At the time, I did the math and came to the conclusion that I needed to take
off more length to get
the resonant frequency high enough in the band.
I loosened the boom guy and rotated the room 90 degrees so the elements were
almost vertical. I
carried a cordless drill up the tower to the first element tip and drilled out
the rivet holding the
last/smallest tube and removed it. I then did the same for the other side of
the element. I didn't
change the lengths of any parasitic elements.
I no longer have the antenna and can't find my measurements, but my
recollection is that it covered
from the bottom end of 15M through most, if not all, of the phone band.
Again, if I am remembering correctly, the 15M driven element has no direct,
electrical connection to
the coax, but is capacitively coupled to the 20M driven element using a single
feedline. The 10M
driven element is connected to the 20M DE with two, parallel wires that I tried
to stretch taut to
keep parallel. If I were to put up another C-31XR, I'd probably use three feed
lines to a remote switch. It would be interesting to try a remote switch
that can be configured to either float or ground the unused ports to see if any
difference.
Jim N7US
-----------------------------------------------------------------
N2TK:
Ron,
Mine resonates at
28.64 - 1.1:1
21.22 - 1.25:1
14.1 - 1.2:1
Single feed.
N2TK, Tony
-----------------------------------------------------------------------
KK9K:
TT'ers,
I just ordered an F12 C31XR. I have been told by experienced users that the
beam can be a pain to
tune properly on 15 (high swr).
I ordered the beam with single feed. Since then I have heard that the problem
is less severe with
the 3 feedline model.
All inputs from experienced users will be welcomed.
Thanks and 73,
Ron KK9K
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|