Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 55 thimbles and turnbuckles

To: wc1m@msn.com, towertalk@contesting.com
Subject: Re: [TowerTalk] Rohn 55 thimbles and turnbuckles
From: DMartin560@aol.com
Date: Wed, 30 Aug 2006 19:56:04 EDT
List-post: <mailto:towertalk@contesting.com>
Just start the thimble on the eye of the turnbuckle by hand and give the 
thimble a couple of whacks with a hammer.  The thimble should spring open and 
go 
into the eye just fine.
Dwayne, KG4ADM

Reviewing the Rohn parts list for a 110â 55G tower @90-100MPH, I decided to
go with Ââ EHS for all three levels (actually, 6700lb Phillystran with Ââ
EHS leaders. Following the parts list, I ordered 3/8â heavy-duty thimbles
(3/8THH) and Ââx12â eye-jaw turnbuckles (1/2TBE&J). Rohn specifies that the
thimble should be one size larger than the guy diameter. The parts have
arrived, and Iâm perplexed to find that the 3/8â thimbles donât fit inside
the eye part of the turnbuckles. I might be able to make them  fit by
flattening the edges of the thimble a bit (sandwiching it between a piece of
two pieces of flat steel and hammering the flare out of the edges), but
before I try that, Iâd like opinions on this. I canât be the first person
who has run into this. It looks like a shackle would work, but Rohn doesnât
specify them for 55G towers. Comments?
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>