On Force 12 antennas you use NoAlOx plus aluminum rivets. This seems to
work quite well. The only negative, and it is minor, is that you must drill
out the rivets to disassemble the element. I just took one apart that has
been up since 1999 and all joints are clean as a whistle with no sign of
corrosion. BTW, the element is installed with the rivets pointing down to
prevent moisture from sitting in the rivets.
73, Keith NM5G
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Cqtestk4xs@aol.com
Sent: Tuesday, August 29, 2006 6:05 AM
To: TOWERTALK@contesting.com
Subject: Re: [TowerTalk] Topband: Thoughts on making low resistance
jointsbetween aluminiumtubing...
In a message dated 8/29/2006 10:20:45 A.M. Greenwich Standard Time,
la5he@otterstad.dk writes:
How do people tackle this problem (and it would include Yagi constructors)
of making low loss contacts at each section where an aluminium tube is
fitted into the previous section.
For Yagis it's easy. I put a small nr 6 stainless screw at each joint .
Before I insert the screw into the hole I put a dab of NoAlox into the hole
and then on the screw. I cover the screw with a few wraps of tape. When
you take the tape off years later the joint is still clean.
Bill K4XS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|