Re: [TowerTalk] How is the best way to bend rebar

[Bill Turner <dezrat@copper.net>]

ORIGINAL MESSAGE:

On Sun, 27 Aug 2006 04:01:23 +0000, "Donald Chester"
<k4kyv@hotmail.com> wrote:

>Cutting it with a hacksaw isn't difficult.  Just saw a small nick in one 
>side, less than 1/4 way through the bar, bend it away from the cut, and it 
>will break into two pieces cleanly.


------------ REPLY FOLLOWS ------------

A cutoff blade in a circular saw works good too. Almost effortless, in
fact.

-- 
Bill, W6WRT
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk