I like to use Scotch-Brite as a plug. It breaths well, is built for moist
applications and bugs apparently hate to crawl on or through it.
73, Keith NM5G
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of K8RI on TowerTalk
Sent: Saturday, August 12, 2006 5:31 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Rotor connector waterproofing?
I had forgotten bout that form of protection which is probably far better
than sealing. It lets the system breathe yet protects it from the elements.
Plastic pop bottles or anything of the sort strong enough to be taped or
clamped into position should work.
Here I'd have to come up with some screen, or maybe something like the
plastic scrubbers to close off the bottom to critters yet let the air flow
in and out freely. Here, bees are a real problem. I go through Wasp and
Hornet killer by the case.
Roger Halstead (K8RI and ARRL 40 year Life Member) N833R - World's oldest
Debonair CD-2 www.rogerhalstead.com
> Paul,
> Here's a technique I use:
>
> http://wa4bpj.com/Ham_Radio/misc/con_in_pipe.jpg
>
> There's a Cinch connector pair pushed up in the pipe. Keeps it dry and
> since it's not bound under layers of tape and sealant, it only takes a
> moment to pull it out of the pipe and break the connection.
>
> 73,
> Mike, WA4BPJ
> www.wa4bpj.com
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Paul Ferguson
> Sent: Thursday, August 10, 2006 1:16 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Rotor connector waterproofing?
>
> I had a Ham IV rotor serviced by Norms and had them install a quick
> disconnect connector in place of the terminal strip.
>
> The short cable from the rotor to the male connector they installed
> has a black sealant around where the cable exits the connector.
>
> I have installed the female connector to my rotor cable and want to
> seal the space where the cable exits the connector. What type of
> sealant is best to use here? The connector is an Amps 9-pin of which
> 8 are used. The female end is labelled 206708-1.
>
>
> What have you found to be the best way to waterproof the mated
> connectors on the tower?
>
>
> 73,
> Paul
> K5ESW
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
