Hi fellas:
I have recently acquired a Ham IV Rotor and CDE controller. I am planning on
getting some Rohn 25 and mounting the rotor.
>From what I understand I will need a Thrust Bearing for load and a Rotor Plate.
(not sure about the thrust bearing) But, I can make the Rotor Plate from scrap
iron with the help of one of the guys from work (a
welder) but don't know the dimensions to make it from.
Does anyone have a manual in pdf form they can send me or a Rotor Plate
Template or something like that for the Ham IV and the Rohn
25 combination?
73 fer nw,
Bob AD5VJ(AAR6VM)
http://www.ad5vj.com/
Member CTDXCC
10X# 37210, FP#-1141
SMIRK#-5177, RARS #-149
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|