I had a Ham IV rotor serviced by Norms and had them install a quick
disconnect connector in place of the terminal strip.
The short cable from the rotor to the male connector they installed
has a black sealant around where the cable exits the connector.
I have installed the female connector to my rotor cable and want to
seal the space where the cable exits the connector. What type of
sealant is best to use here? The connector is an Amps 9-pin of which
8 are used. The female end is labelled 206708-1.
What have you found to be the best way to waterproof the mated
connectors on the tower?
73,
Paul
K5ESW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|