I have a full sized M2 40M3 yagi at 120ft. It's been up about 5 years. The
distal element taper is aggressive, ending with a 3/8 inch diameter tip on
each of the six elements. Too small in hindsight!
The 3/8 inch element tips are failing (it appears from a vibrational
mechanism). It's disconcerting tofind a 20 to 30cm section of aluminum with
the mower blade :-)
Q1). Has anyone else had this problem with the M2?
Q2). Has anyone else modeled and/or implemented a less aggressive taper
ending at 1/2 inch distal tips?
Thanks in advance...
73, Scott W3TX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|