As the once proud owner of a HBDX 48 (still up just not too proud now) I have a
few tips about this beast.
1; Think about replacing existing bolts with heavy galvanized (these are the
architectural grade that require nuts over sized to fit) or stainless steel
bolts of the same grade. The original had rust starting in less than a year, in
my environment anyway.
2. Torque the bolts with a torque wrench with no lubricant on threads or nut
face.
I had failure at the connection between the second and third sections. The
holes on one leg elongated mid winter and before I could get to it to splint
it, it actually tore the bottom 2 inches off the third section leg. As you
probably know the legs are just a rather light gage sheet metal and seem to be
not a particularly high strength steel.IMHO
3. The sheet metal is galvanized before shearing and bending leaving the
edges sharp and only protected from rust by the sacrificial effect and whatever
zinc is smeared by the shearing edges. Maybe painting with a zinc rich paint
could extend life. Some sections of my tower have rusted a lot more than others.
4. The cross braces are riveted to the legs with aluminum rivets. Think about
this and any torque moments you are applying to the tower. Mine hasn't failed
but I personally know of several that failed, one with personnel on it.
5. Some type of bearing or sleeve needed at top. Again here is a place where
just thin sheet metal is used and the holes tend to enlongate if mast/boom
combination get very large. In my case i used a two foot piece of rigid conduit
(GRC) and a floor flange with four bolt holes. I also used a diagonal brace
from the top of the stub to each top of leg using the prepunched holes there to
attach to tower. The slightly larger than 2 inch I.D. allows plenty of room for
a strong mast. The only antenna I ever had on it was a 24 foot home brew 6 mtr.
6L a foot above stub sleeve. That and a 16x16x6 junction box 18 inches from
tower top was all the load on tower prior to failure at 2/3 section.
To keep the tower from further destruction all I was able to do was to put a
guy wire out from the failed leg at the 3/4 junction to keep the tower from
rocking in the wind and coming down. I now need a crane to remove, as I can't
find someone dumb enough to climb the tower and gin pole it down. ;-)
Climbing this type of tower is an exercise in minimumizing the number of cuts
from sheared parts and no horizontal members. Leather gloves and shoes a
minimum.
May better planning than I used bring you luck on your installation.
73
Nick
WB7PEK
---------------------------------
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+
countries) for 2¢/min or less.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|