This should never be done, period. The reason is, think about it, during a
major energy surge event, tremendous heat may be present during large current
flows and any kind of soldering/brazing/etc will melt and you will be left with
no or a very bad connection.
You can do two things:
1. Exothermic connection (CadWeld, etc)
2. Mechanical connection (will require frequent maintenance since mechanical
connections will loosen on their own due to thermal cycling)
Do not solder or braze. Phil KB9CRY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|