Thanks to all who sent me the page "HA-90.pdf" directly...
After taking a second look, I finally found the missing pages on
the rohn website... they were in a different location than the
other "45G" stuff, but I now have everything I need...
Now, off to cut rebar...
73,
George - Ku3o
PS - It would be nice if Rohn would put the Whole catalog as a
single pdf... instead of snippets of pages from it in various locations...
... are you listening Rohn? :-)
Thanks,
----- Original Message -----
From: "George Perkins - Ku3o" <gperkins@tampabay.rr.com>
To: <towertalk@contesting.com>
Sent: Tuesday, June 27, 2006 3:06 PM
Subject: [TowerTalk] 70' Rohn 45 Anchor & Rebar Details
> Folks,
> I am trying to figure out what my rebar detail is for my anchor
> holes on a 70' Rohn 45 (110mph config).
>
> I've seen folks reference the Rohn Catalog page HA-90,
> however, it is not in my catalog....
>
> (I'm using a downloaded Acrobat pdf version from here...
> http://www.criticaltowers.com/ROHN%20Industries/2005%20Catalogs/catalog_downloads.htm
>
> However, this version of the catalog does not have a
> page HA-90.... it only goes up to HA-23... and the
> rest of the document from the link above has no reference
> either....
>
> What I am trying to figure out is what my rebar must
> look like for the anchors (I have the tower base info)
>
> Guage? Shape? Direction of runs? Spacing? etc...
>
> Can someone email me a diagram or a scan of the
> appropriate pages... or describe it to me....
>
> My hole is 3x3 x 4' deep... I just need the rebar config...
>
> Thanks!
> George - Ku3o
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|