Sure. Let me see what I can do. I have the original which should be easy to
copy.
Rich
-----Original Message-----
>From: "Allen R. Brier" <britech@earthlink.net>
>Sent: Jun 21, 2006 12:59 PM
>To: wn0x@earthlink.net
>Subject: RE: [TowerTalk] Wire Rope - Hy-Gain HG70-HD Crank Up
>
>Hi Rich,
>
>I cannot answer your question directly, but I also just bought an HG-70HD.
>Would it be possible to get a copy of the manual from you? I will be happy
>to cover any reproduction costs.
>
>73,
>
>Allen Ross Brier, N5XZ SET
>BriTech Systems Incorporated
>NICET Fire Alarm Level IV
>NICET Sp. Hazards / Sprinkler Systems Level I
>1515 Windloch Lane
>Richmond, Texas 77469-2553
>(281) 342-1590
>(281) 342-0940 (FAX)
>(713) 705-4801 (Cell)
>-----Original Message-----
>From: wn0x@earthlink.net [mailto:wn0x@earthlink.net]
>Sent: Tuesday, June 20, 2006 8:47 PM
>To: towertalk@contesting.com
>Subject: [TowerTalk] Wire Rope - Hy-Gain HG70-HD Crank Up
>
>I am rebuilding a well used HG-70HD. At some point in its life the cables
>were replaced. It now has 3/8 inch wire rope for the lower sections and 1/4
>inch for the upper sections. In both cases wire clamps were used instead of
>the crimped fittings.
>
>According to the manual, the lower section orginally had 3/16" wire rope,
>and the upper section 1/4" wire rope. I am concerned for the accuracy as
>the manual has "HG-54HD" in places where it should have HG-70HD.
>
>Is 3/8" correct? If someone could actually check their HG-70HD to verify
>this I would appreciate it.
>
>I believe the 3/8" cable is causing problems, especially the very large
>cable clamps. If it is supposed to have 3/16" cable I would like to use
>that if possible, as it will be easier to find a swaging tool.
>
>Also, one of the pulleys has completely lost its brass bearing, the others
>are very worn. Has anyone found a source for these pulleys? I will take
>them to a machine shop tommorrow to see if they can replace them.
>
>Thanks,
>
>
>Rich Beckwith - WN0X
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|