Craig,
Looking at the photos on your site, I noted that it seems that the LMR600 is
in the rotator loop. Is that what is happening here and if so, how does the
LMR600 handle being rotated back and forth?
Vy 73,
Gordon Beattie, W2TTT
201.314.6964
w2ttt@att.net
w2ttt@att.com
w2ttt@arrl.net
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Craig Thompson
Sent: Sunday, June 11, 2006 11:39 PM
To: towertalk@contesting.com
Cc: ah6fc@yahoo.com
Subject: [TowerTalk] Rotator Questions
Bill:
I was concerned about the rotator also. The 2800 gets alot of work at my QTH
and I am pleased with its performance. I have the MonstIR, 2m and 70cm
antenna in a US Tower HDX 589 tower. It is the biggest rotator that will fit
the top section of that tower. The Prosistel won't fit per UST. Prosistel
had a new one at Dayton but am not sure that it is bigger than the 2800 or
will fit. I run the 2800 at its slowest speed because of the torque from the
antennas.
Good luck with your decision.
73, Craig K9CT
www.k9ct.us
k9ct@arrl.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|