Of course it must be guyed at the top and probably above the centre to
prevent buckling.
I was not talking about guying the bottom section which would be useless.
Is there any reason for that particular tower not to become guyed?
Cheers
Peter
_____
From: K7LXC@aol.com [mailto:K7LXC@aol.com]
> you will most likely not install both beams at one level.
When one will be stacked above the other you cannot just add the wind loads.
The upper one puts much more bending force on the tower then the lower one.
You probably have to lower it during high winds or support it with guying.
Guying it won't be helpful. You can only guy the bottom section but
the failure point will be in the un-guyed upper 1/3 or so of the tower, not
the bottom section.
Cheers,
Steve K7LXC
TOWER TECH -
Professional tower services for commercial and amateur
Cell: 206-890-4188
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|