Gil said: "Included with the base bearing is a collar with setscrew. Collar
is machined with an eccentric 'rabbet' (for lack of a better word) in one of
the two flat sides.
The bearing has a mating eccentric machined on it. The shaft of the mast is
not large enough to enable the collar's setscrew to fix it in
position.".............
Hi Gil, The base bearing isn't shown/described in the paperwork or
installation plans??
If not, sounds like a call to the manufacture is in order.
Good luck with the project.
73
Jake K9WN
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|