I just do the design with a constant diameter as it means a lot less entries.
Then once the design is complete I do the taper schedule based on required
mechanical strength for the elements. I use the taper schedule based on
Lawson, Dr. James L., "Yagi Antenna Design" ARRL 1986
Denis with Ve6fi
Message: 7
Date: Fri, 31 Mar 2006 19:10:58 -0600
From: K4SAV <RadioIR@charter.net>
Subject: Re: [TowerTalk] 100ft 80meter Yagi
To: towertalk@contesting.com
Message-ID: <442DD322.2050207@charter.net>
Content-Type: text/plain; charset=us-ascii; format=flowed
I notice the model uses 2 inch diameter elements throught out, which
can't be correct. What it the taper schedule for the elements?
Jerry. K4SAV
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|