I had my DirecTV dish on the same tower as my beam and the cables were
close and parallel to my feedlines/control cables for 75 feet or so.
Never heard a peep from the DirecTV power supply. There's no reason
that a properly shielded and filtered switching supply should cause
problems anyway. My IC-765 has an internal switching power supply that
is completely quiet on all bands.
73, K8AC
Mark Adams, PE wrote:
> Hi Gang,
>
> I am ready to install direct burial cabling between my tower and
> basement. This includes 3 runs of BuryFlex, one run of 1/2" TV hardline,
> rotor cable, 12/2 UF for an outlet at the tower base (which will be plug
> connected inside, and two RG-6 w/Ground for DirecTV. The dish will be on
> a pole a few feet from the main tower. My VHF rover partner suggested
> that the DirecTV may use a switching PS for its multi dish switch and
> that I may be QRMing my ham installation. Has anyone done this or have
> any direct experience? At my previous QTH the ham stuff and sat stuff
> was well separated.
>
> 73,
> Mark/K2QO
> FN03ra
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|