I think these types of rotors; very much like the Create rotors which are
worm-gear driven, requires that the vertical loads be put on the rotor and not
relieved by a bearing. Confirm that in your manual.
Mike, K5UO
Hello.
Can the Rohn AS25G accessory plate be cut easily and with what type of saw?
Without sacrificing strength can a Yaesu rotor GS-450 be mounted on a cut
plate? I will be using a thrust bearing (TB3) for the vertical load. Does the
AS25G accommodate the Yaesu rotors without having to re-drill mounting holes?
Thanks
Bruce
K4BOF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|