In a message dated 2/26/2006 9:02:32 A.M. Pacific Standard Time,
towertalk-request@contesting.com writes:
> I have a used Rohn 55G base plate , in good condition, that I was using
as a
Rohn 45G top plate, with a hole cut out in the center for a 3" mast. Best
offer from Zip Code 27576, near Raleigh, NC.
Does that mean that the tower is installed upsidedown? Otherwise how
did you get the plate to bolt on or did it just bolt on (allowing for the
difference in the leg sizes between 45G and 55G)?
Cheers,
Steve K7LXC
TOWER TECH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|