Scott:
The August 1996 issue of QST ran an article titled, "Install a
House-Bracketed Tower--the Right Way!" by K1KP. Tony describes the engineering
work that went into his house-bracketed tower installation. FWIW.
73 de
Gene Smar AD3F
-------------- Original message ----------------------
From: kb0fhp@comcast.net
> I have purchased several sections of Rohn 25G - 3 straight sections, and the
> 8'
> top section with rotor plate. I want to attach this to the side of my
> two-story
> house, at two locations (top header board, and the bottom board on the second
> story). This is about 10' and 20' up from grade.
>
> What additional things do I need to purchase besides the 10' piece that goes
> in
> the concrete; the house brackets; and a thrust bearing for the mast - what
> else
> is required?
>
> Antennas planned are Hy-Gain TH3-MkIII, CC 505S, CC 215 and a M2 432-9wl
> antenna....
>
> Thanks in advance for your suggestions.
>
> Scott, KB0FHP
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|