| To: | towertalk@contesting.com |
|---|---|
| Subject: | Re: [TowerTalk] Fw: motorizing the hand winch on a US Tower MARB550 |
| From: | Dino Darling <k6rix@earthlink.net> |
| Date: | Thu, 23 Feb 2006 09:55:40 -0800 |
| List-post: | <mailto:towertalk@contesting.com> |
>Cut a Socket Extension Shaft and ground it to fit a 1/2" Drill Chuck; $5 >Bought a Socket at Sears that fit the Winch Nut; $8 >Borrowed a 1/2" variable speed reversible drill .. low RPM mode (350 >RPM); FREE Not having to crank a tower; PRICELESS There are some things money CAN buy, for everything else there's TOWERTALK! Dino...k6rix@earthlink.net _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Parallel feedline switching (was 'feed line?'), Mark . |
|---|---|
| Next by Date: | [TowerTalk] LMR600, Courtney Judd K4WI |
| Previous by Thread: | Re: [TowerTalk] Fw: motorizing the hand winch on a US Tower MARB550, Al Williams |
| Next by Thread: | [TowerTalk] Documant request was " Interlaced 20m and 40m yagi on thesame boom.", Robert Thain |
| Indexes: | [Date] [Thread] [Top] [All Lists] |