Hello Team,
I just picked up my Loos gauge to check the guy
tension on my towers and noticed that the pointer is
not resting on zero, as I would expect, but rather
between 3 and 4. I can't push it any further toward
zero because it is at the end of its travel. No broken
or bent parts etc. I would like to think that I would
have noticed this before and that it originaly was at
zero but I can't remember.
In any case, what is the collective wisdom about this?
Has anyone else seen this problem? Or do I have a
fluke, no not the meter :-)
Tom
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|