Towertalk
[Top] [All Lists]

Re: [TowerTalk] 6lb Moxon "tower"?

To: Jim Miller <jim@jtmiller.com>
Subject: Re: [TowerTalk] 6lb Moxon "tower"?
From: Fred Roberts <froberts@ispwest.com>
Reply-to: w6tkv@arrl.net
Date: Mon, 12 Sep 2005 11:31:59 -0700
List-post: <mailto:towertalk@contesting.com>
Jim-

When I read your message, the first thing that popped into mind was a flag 
pole. 
Raised the flag most of the time, raise the 6 pound antenna other times.

In a more direct answer, with just a 6 pound load a length of fencing top rail 
might 
serve you very well - just go visit a local fence company and see what diameter 
(and 
weight) might serve you best.  If you have room, a simple pivot at the base and 
a 
eyebolt at the lifting point might be just the trick for you.

73-
Fred, W6TKV

Jim Miller wrote:

> I'm building a 20M Moxon which will weigh about 6lbs. Rotation by 
> Armstrong... I live in a antenna restricted neighborhood and would like to 
> erect the antenna on an "as needed" basis on some sort of 30ft pushup tower. 
> I have no experience with such antenna supports.
> 
> The antenna is designed to be rapidly and easily assembled in about 5 
> minutes. I'd like the "tower" to be also easily erected if possible. My 
> backyard includes a deck which could provide support to the first 8ft of the 
> "tower". I'd like the remainder to be self supporting of itself and the six 
> pounds of antenna. This doesn't need to be a backpackable tower; 8ft or so 
> sections would be fine.
> 
> This structure doesn't need to survive storm winds or icing but it would be 
> nice to leave it up to work in 25mph breezes. The antenna elements are made 
> from four 16ft tapered telescoping crappie poles and strung with #18awg so 
> should present a fairly low wind cross section.
> 
> I've seen 30ft galvanized tubular pushups at Lowes for $50 or so which have 
> included guy rings. I'd like to avoid guying if possible. Any hope for one 
> of these without guys to support in the manner described?
> 
> I've looked at the specs of the telescoping antenna poles and they appear to 
> be too willowy to meet the requirements. There are some flagpoles which are 
> telescoping however that seem to withstand a nasty windload while flying a 
> pretty good size flag. One example is 
> http://www.sunsetter.com/FlagpoleProducts.asp. Big bux however...
> 
> Anyone had any experience with one of these?
> 
> Am I completely out of luck? If absolutely necessary I suppose I could put 
> down a three small ground screw anchors that I could cover over when not in 
> use and use them as guy anchors...
> 
> Suggestions welcome.
> 
> 73
> 
> jim ab3cv 
> 
> _______________________________________________
> 
> See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless 
> Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any 
> questions and ask for Sherman, W2FLA.
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> 

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>