At 08:49 AM 8/12/05, Tom Rauch wrote:
>and read the warning at....
http://www.w8ji.com/mfj-259b_calibration.htm
Tom, that has been corrected
in the online version. I don't recall it in
my '98 vintage manual either so your
warning about the 2002 revision sounds
right.
From the Vf (p 21) and DTF (p 17)
procedures of the online manual:
3.) Tune the analyzer higher or lower in frequency until the Impedance
meter reads the very next impedance
minimum, and where reactance displayed on the LCD again crosses zero. A
non-zero minimum of a few
ohms is acceptable.
73, Bill W4ZV
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|