Towertalk
[Top] [All Lists]

Re: [TowerTalk] ...Compressed Air Driven Tower

To: towertalk@contesting.com
Subject: Re: [TowerTalk] ...Compressed Air Driven Tower
From: Ian White GM3SEK <g3sek@ifwtech.co.uk>
Reply-to: Ian White GM3SEK <g3sek@ifwtech.co.uk>
Date: Thu, 30 Jun 2005 07:51:27 +0100
List-post: <mailto:towertalk@contesting.com>
Jim Lux wrote:
>
>More seriously, those things are pretty cool. There are several 
>manufacturers of them.  They use them for news vans as well.  Do you 
>have any information on the air pressure and volume required (some are 
>fairly low pressure, high volume.. others are high pressure, low volume).
>
>Properly maintained, they'll cycle up and down several times a day for 
>years. They're also pretty fast (as in seconds to extend).
>
>What they may not have is a huge amount of sideload capability, 
>especially while extending or retracting.  The ones I've seen have been 
>designed for a top load of a few square feet (maybe 6-7).

I had two of these things for some years. They work pretty much as Jim 
says... but there are some major disadvantages for long-term use at a 
home station.

The main problem is that they rely on a very delicate feather-edged ring 
seal at the bottom of each section. A typical mast has 8-10-12 of these 
seals, and if any one of them fails...

The main problem is water inside the mast. Any rainwater runs down the 
outside of each section, and is then trapped inside the next section 
above the seal. When you de-pressurize the mast, that water goes right 
inside to the bottom. For home-station use, you won't want to keep a 
noisy compressor running, so you can lock each section in place... but 
then the seals relax, and a *lot* of rainwater runs down the inside.

So every time you lower the mast, it spits out a horrible mess of greasy 
water. And you don't dare to raise or lower the mast in freezing 
conditions, for fear of tearing the seals.

Because the inside of the mast is always wet, corrosion can make a 
strip-down very difficult indeed. The ones I've used are a nightmare of 
tiny parts, including more than a hundred 3/16in screws...  steel 
screws, corroded into aluminum.

Bottom line is that these masts are great for their intended purpose: a 
mast that can go up anywhere, for a short time, and then you let it down 
and move on.  But they require *constant* attention.

The only time I'd recommend one for home-station use is if you're in a 
really tight corner and there's absolutely no other way to get an 
antenna up.


-- 
73 from Ian G/GM3SEK
_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>