Re: [TowerTalk] How to check trap resonance

[Roger D Johnson <n1rj@adelphia.net>]

> In the dark recesses of my memory, I remember seeing an article about
> determining trap L/C values by using an RF bridge to take measurements
> of the trap above and below the traps resonant refquency. Once the L/C
> values are determined, the resonant frequency can be calculated.
>
> Many years ago, I wrote a BASIC program to determine the L/C values to
> resonate an antenna on two bands simultaneously. I used it with a 3/8
> wave vertical on 160 and 80m. I used a modeling program to determine the
> reactance required at the antenna base for each band. These values were
> plugged into the program which would then  calculate proper the L and C
> values. The result looked like a parallel resonant trap but didn't
> operate that way. I think Butternut uses the same technique with their
> antennas.
>
> I think the program could be modified to operate in reverse. Knowing the
> reactance values above and below Fr, the L and C values could be
> calculated.
>
> 73, Roger

Unfortunately, the coffee hadn't kicked in when I typed the above. It
occured to me that my program is just fine "as is". You measure the X
values above and below the trap resonant frequency and input it to the
program along with the frequencies and it will give the L and C values
for the trap.

I also found this site with some more data:

http://www.smeter.net/antennas/notatrap.php

73, Roger

--
Remember the USS Liberty (AGTR-5)
http://ussliberty.org/
_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk