Towertalk
[Top] [All Lists]

Re: [TowerTalk] R8 vs 6BTV, etc.

To: towertalk reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] R8 vs 6BTV, etc.
From: doc <kd4e@verizon.net>
Reply-to: kd4e@verizon.net
Date: Sat, 29 Jan 2005 17:05:05 -0500
List-post: <mailto:towertalk@contesting.com>
Charlie wrote:
I was in the same sort of quandary some months back that is, in choosing a multi-band vertical. I happened along to www.dxengineering.com where the 4-5-6BTV Hustlers are revered. I purchased a 5-BTV along with the 60 connection stainless steel radial plate and the tilt-over bracket mounting fixture. I have read also many favorable reports on the Hustler BTV line.

As far as power robbing aspects I know of none. I have photos of my 5-BTV installation and swr plots at
1. http://www.ad5th.com/5-BTV.html

Once the xBTV vertical has been tuned to satisfaction what is the value of the tiltover?

Here in Florida I suppose when heavy storms approach one might
lower it ... hmmm.

I used multi-conductor flat rotator control cable with separate
strands cut to 1/4 wave on the various bands as the groundplane.
Had to add a second set to get acceptable results, once the
house is done I will relocate to the permanent location and
add a couple of additional lengths.


-- Thanks! & 73, doc kd4e

                   ~\~
|--------------------|--
| QRO in WCF! | ||'""|""\__,_
| _____________ l ||__|__|___|)
|(@(@)""""""""**|(@)(@)***|(@)

West Central Florida  100% Linux.  Suse 9.2
Halli, Heathkit, Homebrew, SBE, TenTec, Yaesu
Radio Life: http://www.gospelcom.net/twr/
Linux-Incompatible hardware is defective!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
_______________________________________________

See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>