ANY feedline repeats the Load Z (Impedance) every
1/2wavelength..remember that must take into account the velocity factor
of the feedline...for normal coax its about 66% so 0.66 x 468/freq in
MHZ = length of 1/2 wl coax at that freq...the only thing about this is
you can use ANY feedline bewteen radio and antenna as long as its 1/2 wl
and the radio will match the antenna (if the antenna is 50ohm +0j
already)....SWR at the radio will be accurate.....if the antenna is NOT
50ohms or has reactance, the feedline will always cause a WRONG SWR
reading at the xmtr unless it is a 1/2 wl (in coax)..
Hope that helps.
Chris
WB5ITT
> -----Original Message-----
> From: antennas-bounces@mailman.qth.net
> [mailto:antennas-bounces@mailman.qth.net] On Behalf Of FireBrick
> Sent: Sunday, October 10, 2004 8:49 AM
> To: TowerTalk List; Antenna List
> Subject: [Antennas] coax 'sweet lenght'
>
>
> I remember discussion that there was a 'sweet length' for
> rg8, rg13 coax lengths. The length was a multiple that gave
> the best match, etc.
> Or is this the Ham version of 'urban legend'???
>
> But senility won't allow me to remember what it was or where
> I stored this info.
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|