In a message dated 9/21/2004 11:26:07 AM Eastern Standard Time,
towertalk-request@contesting.com writes:
I need some help with a balun for a TB6Em too.
Can anyone tell me if the balun is 1:1 or 4:1??
73, Tom W8JI
====================
Tom,
It should be 1:1, it uses a coil of Coaxial cable and a length of #10 of
insulated wire to make the balun.
I had the predecessor to the TB6E called the TM-30C, it was the same
design,using a hairpin loop for Z transformation. I am sure the later models
use the
same balun design, Mike was not much for change.
PS I enjoyed your article on receivers in World Radio.
Regards,
Norm W4QN
"The Power of a Cubex Quad"
http://www.cubex.com/
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|