US Towers rotor plates can be drilled for the HY-Gain rotors. I think they
can be factory drilled for the Yaesu rotors. You should call them and check
this out to be sure. The AlfaSpid rotor can be purchased with a adaptor
mount to mate with the HY-Gain rotor plates.
Julio, W4HY
----- Original Message -----
From: "Bruce Osterberg" <bruceosterberg@msn.com>
To: <towertalk@contesting.com>
Sent: Friday, September 10, 2004 12:28 PM
Subject: [TowerTalk] US Towers HDX-572
>
> On this US towers 72 Foot Heavy duty tower it comes standard with a Rotor
> Plate. Is the rotor plate drilled for a specific Type of Rotor, eg,(Ham3,
> Ham4, T2X, yaesu etc)? , Reason for asking is that I would like to
purchase
> one of these towers but would be putting in an ALPHA-SPID rotator, so I
need
> an adapter plate with a 2" in Diameter Pipe coming off the top of the
Plate
> to Mount the rotor too.
>
>
> N9BX 73 Bruce
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|