Hi Mel,
The diameter of the head of both bolts is 9/16".
I can't tell you the thread pitch since I am not familiar with that
term.
I am very skeptical of these bolts sold to me as "Rohn Hardware",
but I wanted to inquire of those more knowledgeable than I.
Tnx & 73
Bob KQ2M
----- Original Message -----
From: <Bgsalesmel@cs.com>
To: <kq2m@earthlink.net>; <towertalk@contesting.com>
Sent: Sunday, August 15, 2004 11:31 PM
Subject: Bolts, ID??
> You didn't state the diameter nor thread pitch. That could be important.
> The "3-letter" identifier on the top, just being stamped there in ink,
makes
> me think these are common grade from Home Depot. This is how the clerk
looks
> up the value and uses a printed/book bar code to charge you at the check
out
> stand. I don't think I would use these on a tower leg.
>
> YMMV, 73
> Mel Frost
> KD7DCR
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|