Towertalk
[Top] [All Lists]

Re: [TowerTalk] Technique for Putting Don Radials?

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Technique for Putting Don Radials?
From: "David J Windisch" <davidw@copper.net>
Date: Tue, 22 Jun 2004 17:25:39 -0400
List-post: <mailto:towertalk@contesting.com>
BTDT except used 500' spools cuz I could carry them.  I small-split-bolted
the ends for a "continuous" run.  Stripped the insulation at the center and
big-split-bolted the radials together in 4 groups.

Next came 2 months of ignoring neighbors' stares and township notices, all
for not mowing the grass.

It's a one-ohm-ground at some frequency.

Works fine, fails safe, drains to the bilge.

73, Dave, N3HE


----- Original Message ----- 
From: "Eric Rosenberg" <wd3q@starpower.net>
To: <topband@contesting.com>; <towertalk@contesting.com>
Sent: Monday, June 21, 2004 5:40 PM
Subject: [TowerTalk] Technique for Putting Don Radials?


> At a recent PVRC meeting, an interesting method for laying down lots of
> radials for a vertical.  Instead of cutting each radial individually and
> attaching each piece to the vertical section, this technique involved
SNIP

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>