RG217 is good for rotor loops, rated about 1000W at 144 MHz,
much much more on HF. You can get both N and DIN 7/16 connectors
for it, PL259 (solder type) connectors can also be fitted.
73 Jim SM2EKM
--------------------------------------------------------------------
K7LXC@aol.com wrote:
In a message dated 3/1/04 4:35:34 AM Pacific Standard Time,
Kingsautomotive1@alltel.net writes:
I am installing a beam or two, and have only coax with solid center.
(Belden 9913, etc.) Has any one used this successfully for the flexing
part?
Maybe a large, carefully supported loop? I have heard of using 1/2 "
corrugated hardline, so maybe it can hold up without breaking where the
mast
rotates. I would like to hear of anyone's experience here.
No one recommends using 9913 or any solid centered coax where it has to
move occasionally; i.e. rotation loop. Besides the center conductor moving
around inside the air dielectric, the solid center conductor will work eventually
work harden and crack - bad news for any feedline. Terminate the 9913 at the
top of the tower and use any old stranded center conductor coax to the beam.
Cheers,
Steve K7LXC
TOWER TECH
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|