Joe, the cable from the winch goes up over the top of the pulley mounted on
the vertical post. Then, horizontally to the top of a pulley mounted on the
tower leg, out the bottom of that to the vertical post where it is attached.
73 and GL, Dan, N5AR
----- Original Message -----
From: WD0M <wd0m@centurytel.net>
To: <towertalk@contesting.com>
Sent: Thursday, November 06, 2003 11:27 AM
Subject: [TowerTalk] TX-455 Question
> I just bought a used TX-455 with the raising fixture. Unfortunately, the
> tower has a part missing where the raising fixture cable attaches. Can
> anyone tell me if there is a pulley missing (and where the cable actually
> attaches), or is there a bolt/pin missing that the cable attaches to.
>
> Thanks in advance.
>
> 73,
> Joe
> WD0M
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|