What I have done in the past when I had to replace the u-bolts on the plate is
to take some "all-thread" and bend it using the tower as the form. Then take a
hack saw and cut the all thread. You can get all-thread from any hardware
store. I before I cut the all thread to size, I would put on the nuts so that
I could roll the nuts off after the cut to straighten out the threads at the
cut. I've also found u-bolts "close" to the size and reformed them for the
tower leg. I like the all-thread method better
Your mileage may vary
Lee - K0WA
"Benson,M Stokley" <BENSONMS@apci.com> wrote:
Hello TT'ers,
In anticipation of having to replace the U-bolts on the Rohn AS25G rotator
plate currently on the tower, what are the U-bolt dimensions (i.e., distance
between legs, overall length and size - 1/4 or 5/16 inch)? Prior to posting I
did the following: 1) looked in my current Rohn catalog; 2) did a Google
search; 3) checked the TT archives; and, 4) sent a message to Stan, W7NI, about
availability of the set (unanswered to date)...all to no avail. Once I know the
dimensions I will order SS U-bolts from McMaster-Carr. Tnx.
73 / Stokley, W3SB
+
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|