As was stated earlier, the large wires on terminals 1
and 2 are for the brake.
Terminals 5 and 6 are for the motor (plus 1 for
common). But don't take my word for it - check the
manual:
http://www.hy-gain.com/man/pdf/HAM-IV.pdf
-Mike N2MG
VA3PL wrote:
> I think I goofed somewhere with control cables (too
> many connectors and too many splices) to the rotor
> and the rotor is rotaiting the other way. When I
> press CW it rotate CCW. It is like CW and CCW are
> reversed. What happen if I reverse wires connected
> to pin 1 and 2? Will the rotor rotate
> the way it should?
________________________________________________
PeoplePC: It's for people. And it's just smart.
http://www.peoplepc.com
|