I just wanted to say thanks again for all the good info on the pigtail
connector. I cut the connector and found that if I routed the rotor wire
through different holes in the top plate, I had enough slack. The corrosion
on the rotor cable side (the connector I soldered) was unbelievable ! It's a
wonder it worked as long as it did. The color of the wires matched up so it
was a piece o' cake. The pigtail side of the connector was packed with
silicon grease. Please note - touching this grease renders any attempt to
tape anything with Scotch 33 useless - no stick, just slick ! Next time up
the tower, I will carry some baby wipes. Got plenty of those, but that's
another story !!
Now, next project is to fix a dead azimuth half of the Yaesu G5500.
Something's shorted. It indicates direction, but no rotation. Hmmmm ...
73, Jamie
WB4YDL
|