There are 3M splice kits for large wire(hooking up motors)(might also come
in smaller sizes too just have not seen them yet) that use this stuff. No
more layers of tape for LV applications. Just bolt the wires together and
stick into the formed plastic tube and click the retaining clip and your
done. M2'd uses this stuff in the VHF/UHF antennas in the matching block.
Neat stuff.
Tom AC5TM
----- Original Message -----
From: "Jim Lux" <jimlux@earthlink.net>
To: <eric@k3na.org>; "Towertalk" <towertalk@contesting.com>
Sent: Thursday, May 22, 2003 10:17 PM
Subject: Re: [TowerTalk] telephone company non-sticky semi-solid stuff
> I would guess some form of silicone gel. As you probably know, silicones
> are available in a bewildering variety of forms, viscosities,
stickynesses,
> etc. When wires were pulled out, did any adhere to the wire?
>
> The other possibility is something like petroleum jelly (aka "grease")
>
>
> You might want to look at the 3M web site (http://www.3m.com/)...
>
> There are interesting things like Scotchcast 2112 Re-enterable Electrical
> Insulating Resin. This is a two part resin that cures soft, and can be
> peeled back.
>
> At 04:30 PM 5/22/2003 -0400, Eric Scace K3NA wrote:
> > I moved recently to Boston. When working with the telephone company
> > engineers to install my phone service, I noticed that my
> >network interface unit contained an unusual, non-sticky, clear,
semi-solid
> >material ("UNSCSSM"). The striped, bare ends of the
> >copper wires were inserted into this material, which surrounded the screw
> >clamps used to connect the wiring together.
> >
> > This UNSCSSM flowed around the screw and wires, preventing water and
> > oxygen from reaching the exposed wire. Wires that had been
> >immersed in the UNSCSSM were readily pulled out, and were still bright
and
> >shiny.
> >
> > Offhand, it seems that a piece of heat shrink tubing containing this
> > stuff could be shrunk around a coax connector, forming an
> >air- and water-tight seal. If the connector needed to be undone, the
heat
> >shrink can be clipped off and the UNSCSSM peels away with
> >no residue. It seems ideal for those tricky places like coax connections
> >to SO-239 sockets on external boxes, where it's very
> >difficult to wrap tape around the socket in such a way as to be
watertight.
> >
> > Does anyone know more about this material?
> >
> >-- Eric K3NA
> >
> >
> >_______________________________________________
> >
> >See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
> >Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
> >any questions and ask for Sherman, W2FLA.
> >
> >_______________________________________________
> >TowerTalk mailing list
> >TowerTalk@contesting.com
> >http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
|