I just finished installing a hazer 4 with roller bearings on my rohn 25g
tower. I was able to test it out a bit and it really operates very smooth.
My question is about the attachment of the S- hook for the catch release, my
rotor shelf I bracket with the catch attached is slightly blocking the hole
that the S hook attaches to. I double checked construction of this area and
it appears to have been done properly. Anybody else have this problem? It
looks like if I force the hook in the way it is its going to jam the catch
and give the hook a very short life span. I was think of just maching out a
bit of a slot in the I-bracket or Just drilling another hole for the S-hook
further back toward the tower Z brace. Any Ideas
thanks
ken w8ob
|