Tom,
Use good protected monitors.With the cheap ones, the troubles and noise are
free.......I use PHILIPS ( 1709 Brilliance ) and a (17T ). Ten and eight
years old, never in off state.
Have to put very heavy Loudspeaker beside it to deform the image.
Should like to swich to 15" flat screens, but I hesitate very much. Affraid
I would meet the same troubles you mentioned.
Somebody knows about flatscreens in a HF environements?
Jos on4kj
----- Original Message -----
From: "Tom Martin" <tmartin@chartermi.net>
To: <towertalk@contesting.com>
Sent: Friday, February 07, 2003 5:55 PM
Subject: [TowerTalk] Monitor Flicker and TX2 Control
> Has anyone experienced monitor flicker when releasing the break on the
> TX2 control unit? When I turn the beams, the 17 "monitor a foot away
> flickers. Is this a magnetic problem? When the monitor was three feet
> away from the control unit there wasn't a problem. Now, I have the
> monitor directly in front of me and I can't move the control unit too
> far away. Any suggestions?
>
> 73,
>
> Tom W8JWN
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
|