I am not familiar with the accessory but some accessories reuire you
place tham at specific locations in reference to diagonal bracing -
there are smal "dents: in those pieces so that the bars can get up close
to the legs of the tower which could not happen if the were obstructed
by the diagonal bracing
73,
Jim, K4OJ
Bill Ralston wrote:
>I've installed the bracket per the drawing, but it doesn't seem right...
>it's just floating on the tower, resting on the cross braces. All of the
>downward guy tension will thus be transferred to the tower through the cross
>braces. Is this right?
>
>The drawing makes it look like the bracket should bear down on the tower
>legs, but it doesn't. This is because the thickness of the two ring fills
>and guy link is greater than the diameter of the tower leg.
>
>I've checked the obvious - they really are 55G sections and a 55GB bracket.
>I'm using all the parts the came with the bracket - not doing anything
>fancy.
>
>Somebody tell me their Rohn 55 tower is like this or help me figure out
>what's wrong!
>
>-- Bill N7VM
>
>
>
>
>_______________________________________________
>AN Wireless Self Supporting Towers at discounted prices,
>See http://www.mscomputer.com
>
>Wireless Weather Stations now $349.95. Call Toll Free,
>888-333-9041 for additional information.
>_______________________________________________
>Towertalk mailing list
>Towertalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
|