Towertalk
[Top] [All Lists]

[Towertalk] Hy-Gain Tail Twister

To: <towertalk@contesting.com>
Subject: [Towertalk] Hy-Gain Tail Twister
From: wa2bpe@infoblvd.net (WA2BPE)
Date: Sun, 13 Oct 2002 16:22:15 -0400
Assuming it worked at one time, either you have developed a high resistance
in the cable to the rotator or the cap is bad.  Don't bother with one of the
"usual" whimpy caps usually found, use a rugged motor starting AC cap and it
will never go bad. Good luck.

73,  Tom - WA2BPE

Bruce Miller wrote:

> I've got a Tail Twister that will not turn when the wind is blowing.
> Has anyone else experienced this problem and come up with a workable
> solution?  I've got an M2 10M7 10 meter monobander, 45 foot boom, 6 sq.
> ft. of wind load, on an 80 foot Trylon self supporting tower.  The TT
> was purchased new by me in 1988, with a factory "tune up" in 1993.  It
> is located inside the tower about 8 feet from the tower top.  We can
> hear the brake release when that lever is depressed, but the antenna
> will not move either cw or ccw.  Last weekend when this happened, I
> tried turning the rotor first thing in the morning and it turned as it
> should.  My first thought is to get a heavy duty rotor that can handle
> the antenna.  But Hy-Gain advertises the T-2X as an "extra heavy duty"
> rotator capable of handling "large antennas up to 20 square feet wind
> load".  The QTH is northeastern New Mexico where the wind blows on a
> calm day at about 15mph!  Ideas?  Is the equivalent of 15 to 25mph winds
> and the torque they produce on a 45 foot boom in excess of Hy-Gains 20
> sq. ft. specification?  Thanks,
> Bruce, AA5BH
>
> _______________________________________________
> AN Wireless Self Supporting Towers at discounted prices,
> See http://www.mscomputer.com
>
> Wireless Weather Stations now $349.95. Call Toll Free,
> 888-333-9041 for additional information.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


<Prev in Thread] Current Thread [Next in Thread>